-40%
SGI O350 MIPS R16 2x600MHz system.
$ 1003.2
- Description
- Size Guide
Description
This listing is for a used Origin 350 rack-mount system it has two MIPS R16K 600Mhz processors,1024MB of Memory a 18Gb HDD and IRIX 6.5.30 installed. It's been tested and is in good working order. sorry no power cords to go with.see pictures for overall condition and contents of auction below is the console output of HINV & Uname command:
IRIS 1# hinv -vm
Location: /hw/module/001c01/node
IP53_2CPU Board: barcode NJA698 part 030-1863-001 rev -D
Location: /hw/module/001c01/IXbrick/xtalk/15
2U_INT_53 Board: barcode NGM131 part 030-1809-005 rev -A
Location: /hw/module/001c01/IXbrick/xtalk/15/pci-x/0/1/ioc4
IO9 Board: barcode MTS418 part 030-1771-005 rev -A
2 600 MHZ IP35 Processors
CPU: MIPS R16000 Processor Chip Revision: 2.1
FPU: MIPS R16010 Floating Point Chip Revision: 2.1
CPU 0 at Module 001c01/Slot 0/Slice A: 600 Mhz MIPS R16000 Processor Chip (enabled)
Processor revision: 2.1. Scache: Size 4 MB Speed 300 Mhz Tap 0xc
CPU 1 at Module 001c01/Slot 0/Slice C: 600 Mhz MIPS R16000 Processor Chip (enabled)
Processor revision: 2.1. Scache: Size 4 MB Speed 300 Mhz Tap 0xc
Main memory size: 1024 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Memory at Module 001c01/Slot 0: 1024 MB (enabled)
Bank 0 contains 512 MB (Standard) DIMMS (enabled)
Bank 1 contains 512 MB (Standard) DIMMS (enabled)
Integral SCSI controller 2: Version IDE (ATA/ATAPI) IOC4
CDROM: unit 0 on SCSI controller 2
Integral SCSI controller 0: Version QL12160, low voltage differential
Disk drive: unit 1 on SCSI controller 0 (unit 1)
Integral SCSI controller 1: Version QL12160, low voltage differential
IOC3/IOC4 serial port: tty3
IOC3/IOC4 serial port: tty4
IOC3/IOC4 serial port: tty5
IOC3/IOC4 serial port: tty6
Integral Gigabit Ethernet: tg0, module 001c01, PCI bus 1 slot 4
PCI Adapter ID (vendor 0x10a9, device 0x100a) PCI slot 1
PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 3
PCI Adapter ID (vendor 0x14e4, device 0x1645) PCI slot 4
IOC4 firmware revision 79
IOC3/IOC4 external interrupts: 1
HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
IP35prom in Module 001c01/Slot n0: Revision 6.210